Regulation on Ecodesign Requirements for Space Heaters and Separate Related Controls (2024/1103/EU) (SGM-2026/1)
AI-generated summary for informational purposes only. Not legal advice. See the original source for the authoritative text.
This Turkish regulation, aligned with EU Commission Regulation (EU) 2024/1103, establishes mandatory ecodesign requirements for domestic space heaters with nominal heat output of 50 kW or less and commercial space heaters (bright or tube-type) with nominal heat output of 300 kW or less per unit or per tube section. It also covers separate related controls placed on the market independently. The regulation sets specific energy efficiency, emission, and functional requirements that these products must meet to be placed on the Turkish market or put into service. It excludes steam-compression or sorption cycle heaters, outdoor-only units, certain low direct-heat-output products, air heating products, sauna stoves, and cooking appliances. Manufacturers, importers, and authorized representatives must perform conformity assessment using internal design control or management system procedures, maintain technical documentation including declared values and calculations, and comply with verification tolerances during market surveillance. The previous regulation (2015/1188/AB) is repealed. The new rules take effect one year after publication.
AI-generated summary. May contain errors. Refer to official sources for legal decisions.
Key Changes
- Applies to domestic space heaters ≤ 50 kW and commercial (bright/tube) heaters ≤ 300 kW per unit or tube section
- Includes separate related controls placed on the market independently
- Repeals previous regulation (2015/1188/AB) published on 26/6/2022
+ 3 more changes with Pro
Obligations
What this law requires
Manufacturers, importers, and authorized representatives must ensure space heaters (≤50 kW domestic; ≤300 kW commercial) and separate related controls meet ecodesign requirements specified in Annex II before placing on Turkish market or putting into service.
Perform conformity assessment using either internal design control system (as specified in EK-4 of Energy-Related Products Ecodesign Directive) or management system procedure (as specified in EK-5).
Maintain technical documentation containing declared values for technical parameters listed in Annex II Article 6 and detailed calculations/results performed in accordance with Annex III.
Measure and calculate ecodesign requirements compliance according to methods specified in Annex III and Annex IV.
Do not place on market or put into service space heaters using steam-compression or sorption cycle technology, outdoor-only units, units with direct heat output less than 6% of total heat output, air heating products, sauna stoves, or cooking appliances.